| auszookers.com http://auszookers.com/forum/ |
|
| Needing a H20a 5spd gearbox or input shaft http://auszookers.com/forum/viewtopic.php?f=8&t=55369 |
Page 1 of 1 |
| Author: | Montys2.5 [ Fri Aug 10, 2018 7:16 pm ] |
| Post subject: | Needing a H20a 5spd gearbox or input shaft |
Chasing a H20a manual gearbox 5 Spd that’s running 20 tooth count on the input shaft and 23 on the gear . Dimension on the input shaft still in box is 170mm from the internal side of the bell housing, The spigot pilot diameter is 15mm. Otherwise if you’ve got a input shaft or know anywhere that does. The measurements are; 230mm (9 inches) in length 20 tooth spline the spigot pilot is 15mm (.55 inch). |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|