[ozhummer]

I am in the process of replacing my wheel bearings and all the seals including the inner hub seals. (Suz part# 09289-48004).

Has anyone ever tries this ?? am I putting the thing on the wrong way, caus I have already stuffed one of them and I can't get the shits on ???

does the rubber go into the hub or does the metal go over the outside - if the later, why are they loose ?

Thanks

[v.w.dave]

If you look on the DIY section there is a complete brake down on how to do this with pictures

[v.w.dave]

ummmm well I was going topost the link for you but I cant find the DIY section.... ummmm ask royce or steve to give you a link to the hub rebuild thread.....

[ozhummer]

v.w.dave wrote:

ummmm well I was going topost the link for you but I cant find the DIY section.... ummmm ask royce or steve to give you a link to the hub rebuild thread.....

Ok - I'm not going mad then .. Can't find it either ? - Anyone got any links???

[303zuke]

ozhummer wrote:

I am in the process of replacing my wheel bearings and all the seals including the inner hub seals. (Suz part# 09289-48004).

Has anyone ever tries this ?? am I putting the thing on the wrong way, caus I have already stuffed one of them and I can't get the shits on ???

does the rubber go into the hub or does the metal go over the outside - if the later, why are they loose ?

Thanks

As the Actress said to the Choirboy, are you sure you've got the right hole?

09289-48004 does not fit in the hub itself, and the part number says its a 48mm seal. The inner seal on the hub is 09283-54001, a 54mm seal, which would explain why your seal is a loose fit (BTW, you would have saved a lot of head scratching and searching if you'd have said VITARA hub!):