[vandle]

Have installed a jimny box and steering pump onto a sierra with a G13a.
jimnys run groove belts and G13a run v belts.
are there any accessory groove belt pullys available that are able to be bolted to the v belt pully on the crankshaft?
any suggestions would be grateful.

[lukes_89]

i think the way to do it is the change from v belts to the multi rib belts that way you can also run a falcon alternator as well

[steak_knife]

Swift with G13 eng in it.

[jdk81]

If you are lucky yoy may find a pulley with single V for alt and waterpump, and a multi V for A/C/PS.

The sierra water pump cant fit the multigroove pulley, so you need to convert to a barina or baleno water pump.
These cant support the rad fan, so thermo fan is required.
And do a falcon alt while you are it, while posted above.

You may find a vit water pump with multigroove, then you can fit the clutch fan and vit fan shroud to the radiator.

If I am misinformed in any way, please let me know. As I haven't done this conversion as yet. But will be doing it to a G16B engine, that I will install soonish.
I have a cressida P/S box, 110A falcon Alt, need to go get a teardrop style P/S pump, and thermo fans.

[BlueSuzy]

Just change the pulleys from the swift g13b multiv's. They easily bolt off.

The Baleno water pumps do support the engine fan, just use the sierra bolts and spacer.

[vandle]

Thanks everyone for your help, I now have something to go on.

[BenT]

jdk81 wrote:

The sierra water pump cant fit the multigroove pulley

The water pump pulley from an 8 valve Vitara will fit the Sierra water pump.

You can fit a Vitara crank pulley once you re-drill the bolt pattern from 5 holes to 4 holes.
For the alternator, just use a Vitara one, then you get a power upgrade as well.

Ben