[Damo]

Has anyone got a degree wheel they've used on a zook? Specifically a G16 double row multi-v type bottom pulley.

I'm not keen on undoing the centre bolt because it's a PITA. I was thinking of epoxying some magnets on a aluminium disk, but keen to hear if anyone else has come up with a better idea.

[ball]

Damo wrote:

Has anyone got a degree wheel they've used on a zook? Specifically a G16 double row multi-v type bottom pulley.

I'm not keen on undoing the centre bolt because it's a PITA. I was thinking of epoxying some magnets on a aluminium disk, but keen to hear if anyone else has come up with a better idea.

I have a big one made by crow that has 4 slots so you can bolt it on to a bolt pattern not just a centre bolt.