[christover1]

Got me a set of these unbreakable engine mounts,
cheap, thanks to Joel.
Actually designed for fitting a Vitara 1.6 to a Sierra chassis.
I figured they fits at motor end easily,
so mod the chassis end and use in my Vitara.
Not finished yet,
but appears motor will sit about 20 - 25 mm higher.
Not an issue, as I have a 50mm body lift.
May also lift gearbox and t-case by same amount.
Only down side,
will need to re route fuel lines,
as they were only just long enuff in stock pozzy.
Pix will come shortly after the swearing ends

[Gwagensteve]

These aren't the petrowprx ones are they?

Steve.

[christover1]

Gwagensteve wrote:

These aren't the petrowprx ones are they?

Steve.

No, they had a bad reputation, so stayed clear of them.
They are from trail tough.
Look ok to me, time will tell I guess

[christover1]