[31zook]

After doing my 3rd set of WT-NT perch conversions i was sick of being on the floor or having to build temp jigs for it, i bought a angle finder from LROR, and this jig, pretty simple, but it does the job On a side note, this is the first time i've seen TSOR's perches, there good quality and a good fit, will never be cutting and trying to use OE again.

takes about 3hrs to do a set of axles now.

[stockman]

Any excuse to use the welder

[Fatzook]

3hrs Takes me 2

Nice beads

EDIT: do the two stands wander and wobble a bit with just the 2 round solid braces? Maybe weld some RHS in between the two I beams.

And sweep ya floor ya bum! The filings are leaving magnetic tide marks on the floor

[31zook]

cheers stockman

Fatzook wrote:

3hrs Takes me 2

Nice beads

EDIT: do the two stands wander and wobble a bit with just the 2 round solid braces? Maybe weld some RHS in between the two I beams.

And sweep ya floor ya bum! The filings are leaving magnetic tide marks on the floor

what ever hero
No, when i have 2 tacks on the axle it's pretty stirdy, not indestrusable, but good enough....