| auszookers.com https://www.auszookers.com/forum/ |
|
| DIY: axle stands https://www.auszookers.com/forum/viewtopic.php?f=14&t=21246 |
Page 1 of 1 |
| Author: | 31zook [ Fri Apr 22, 2011 11:01 am ] |
| Post subject: | DIY: axle stands |
After doing my 3rd set of WT-NT perch conversions i was sick of being on the floor or having to build temp jigs for it, i bought a angle finder from LROR, and this jig, pretty simple, but it does the job  On a side note, this is the first time i've seen TSOR's perches, there good quality and a good fit, will never be cutting and trying to use OE again.
takes about 3hrs to do a set of axles now. 
|
|
| Author: | stockman [ Fri Apr 22, 2011 11:31 am ] |
| Post subject: | Re: DIY: axle stands |
Any excuse to use the welder 
|
|
| Author: | Fatzook [ Fri Apr 22, 2011 12:04 pm ] |
| Post subject: | Re: DIY: axle stands |
3hrs  Takes me 2 
Nice beads 
EDIT: do the two stands wander and wobble a bit with just the 2 round solid braces? Maybe weld some RHS in between the two I beams. And sweep ya floor ya bum! The filings are leaving magnetic tide marks on the floor 
|
|
| Author: | 31zook [ Fri Apr 22, 2011 10:40 pm ] |
| Post subject: | Re: DIY: axle stands |
cheers stockman
Fatzook wrote: 3hrs
Takes me 2 Nice beads EDIT: do the two stands wander and wobble a bit with just the 2 round solid braces? Maybe weld some RHS in between the two I beams. And sweep ya floor ya bum! The filings are leaving magnetic tide marks on the floor what ever hero
No, when i have 2 tacks on the axle it's pretty stirdy, not indestrusable, but good enough.... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|