auszookers.com
https://auszookers.com/forum/

Transfer lever tool
https://auszookers.com/forum/viewtopic.php?f=14&t=22902		 Page 1 of 1
Author:  zukenutter [ Thu Jun 16, 2011 7:07 am ]
Post subject:  Transfer lever tool
Special Tool #2 :lol:

Made this this arvo to install the transfer lever. I've always found this to be difficult to install and with the position it sits in on the Jimny it's impossible.

This should work a treat. Yeah and I know my welds suck :thefinger:

Ingredients;
1. 3/4 inch washer
2. old flange nut
3. one really small nut

Image
Image
Image
Author:  AxL_ [ Thu Jun 16, 2011 10:05 am ]
Post subject:  Re: Transfer lever tool
top shit custom tools kick ass good work :)
Author:  Gwagensteve [ Thu Jun 16, 2011 10:19 am ]
Post subject:  Re: Transfer lever tool
What's wrong with cutting your fingers every time you put the lever back in? HTFU man! :D

(j/k - nice little tool)

Steve.
Author:  zukenutter [ Thu Jun 16, 2011 10:31 am ]
Post subject:  Re: Transfer lever tool
Cheers guys, I'm pretty happy with my 45min tool. I spent over an hour on Wednesday trying to do it by two finger method from underneath, was thinking I'd have to pull the transfer, again! This was way easier :D
Author:  suzooky87 [ Thu Jun 16, 2011 11:29 am ]
Post subject:  Re: Transfer lever tool
nice one. that is a great idea A++
Author:  zukenutter [ Fri Jun 17, 2011 12:36 am ]
Post subject:  Re: Transfer lever tool
worked perfectly, this is such an easy job now.

I'm going to modify it slightly by cutting a passage through one side so it doesn't have to slide down from the top of the lever.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/