bit of an obtrusion on the rear
.
I think i would have cut them so they angle to the body abit more with end caps to smooth the edges..Or with bends so they form around the rear.
Sorry but thats my 2 cents
| auszookers.com https://www.auszookers.com/forum/ |
|
| Steel Vitara tube bumper https://www.auszookers.com/forum/viewtopic.php?f=14&t=2387 |
Page 1 of 1 |
| Author: | The_GRIZZ [ Mon Jun 30, 2008 2:32 am ] |
| Post subject: | Steel Vitara tube bumper |
Here we go it is made from 3inchx3.2mm steel tube and is 1600mm long. |
|
| Author: | BlueSuzy [ Mon Jun 30, 2008 3:20 am ] |
| Post subject: | Re: Steel Vitara tube bumper |
bit of an obtrusion on the rear .
I think i would have cut them so they angle to the body abit more with end caps to smooth the edges..Or with bends so they form around the rear. Sorry but thats my 2 cents
|
|
| Author: | Scrawny [ Mon Jun 30, 2008 2:24 pm ] |
| Post subject: | Re: Steel Vitara tube bumper |
BlueSuzy wrote: bit of an obtrusion on the rear
.You'll only catch your nuts on them once, then you'll quickly learn not to do it again!!
|
|
| Author: | The_GRIZZ [ Mon Jun 30, 2008 6:40 pm ] |
| Post subject: | Re: Steel Vitara tube bumper |
It's the angle of the pic it doesn't actually stick out the sides of the car and i am still lookin for end caps. still at around 16kg if some one runs up the arse of the zook their car is gonna be a complete mess 
and one more thing the last pic with that trailer behind the zook that trailer was full of palm parts and the zook still towed it at 80km/h, full consumption goes out the window. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|