| auszookers.com https://www.auszookers.com/forum/ |
|
| soft top rear divider https://www.auszookers.com/forum/viewtopic.php?f=14&t=33287 |
Page 1 of 1 |
| Author: | warrior64 [ Sat Jun 09, 2012 12:51 pm ] |
| Post subject: | soft top rear divider |
I have seen someone post a pic of their divider they made up out of marine ply.The divider is for a soft top to make the front cab as "secure" as can be and reduce noise and wind bufffeting from the rear . Does anyone have specs for the odd shape of the area that is behind the seats and where the divider goes? I was thinking of getting a large sheet of butchers paper and scribing it on as a template ? |
|
| Author: | douglasgiersch [ Sun Jun 10, 2012 7:56 pm ] |
| Post subject: | Re: soft top rear divider |
IMO grab some cardboad (try the back of safeway or coles and just ask the workers for a big bit) cardboard will be able stand up and hold its wieght unlike butchers paper which would just flop around, will make it alot easier. I am shortly going to make one for my swb sierra and will use cardboard. |
|
| Author: | warrior64 [ Mon Jun 11, 2012 12:10 pm ] |
| Post subject: | Re: soft top rear divider |
Tried plastic sheeting = Bastard. Tried card board = Semi bastard ,but a basic template . At least ive got a rough template now but will have to trim up a few practice ply sheets before a nice tight fit is found ! Once I have a fited rear divider, I will fit a perspex window into it so I can see the trafic im holding up ! |
|
| Author: | zooky08 [ Mon Jun 11, 2012 1:42 pm ] |
| Post subject: | Re: soft top rear divider |
viewtopic.php?f=14&t=19730&start=30 some thing like this, first pic on page. They did put the window in upside down though. |
|
| Author: | SierraDan [ Mon Jun 11, 2012 8:51 pm ] |
| Post subject: | Re: soft top rear divider |
Or put it that way to make better use of available vision with the window that way. |
|
| Author: | got_bar_work [ Wed Jun 13, 2012 6:58 pm ] |
| Post subject: | Re: soft top rear divider |
3mm mdf sheet is the bomb for templets U can cut it with a knife, saw, drill it, sand it Its strong but can be bend |
|
| Author: | coily96 [ Wed Jun 13, 2012 10:39 pm ] |
| Post subject: | Re: soft top rear divider |
I used cardboard double thickness. viewtopic.php?f=14&t=19191&hilit=marine+ply Mine was half the height you want to make up, but u get the idea. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|