auszookers.com
https://www.auszookers.com/forum/

Aerial roof mount GV
https://www.auszookers.com/forum/viewtopic.php?f=14&t=4629		 Page 1 of 1
Author:  gvzookdriver [ Sat Apr 18, 2009 11:49 pm ]
Post subject:  Aerial roof mount GV
I dont have a bull bar ( and dont quite have the money to put on on either) and needed somewhere to mount my aerial i have seen someone weld a plate off the spare wheel carrier good idea but i dont have a welder :( so next best option was to mount it on the roof rail ( better reception) lots of planing and trying out different designs till i just had to keep it simple stupid (KISS) here are a few little pics of the final product -

sorry about the different size photos

installing CB

Image

Installed

Image

chossing the position for the Aerial

Image

moulded to roof rail

Image

top view

Image

what you see from the side sits flush with rail

Image

side view

Image


when cb is in use (can have every angle in between

Image
Author:  bitingmidge [ Sun Apr 19, 2009 12:19 am ]
Post subject:  Re: Aerial roof mount GV
That's a super neat install! Did you run the cable internally or just through the door opening?

I'm still struggling with where to locate the set, the aerial currently sits way too low on a bracket above the number plate. Neat, but not all that very best!

Every other current series GV I've seen simply mounts the radio to the passenger side of the console, I'm trying to do better and would welcome any thoughts!

The aerial might end up on the roof bars yet ;)

Cheers,

P
Author:  Scrawny [ Sun Apr 19, 2009 1:39 am ]
Post subject:  Re: Aerial roof mount GV
Yeah, very neat install!! I like the 4400 purely for the fact that it is din size, looks neat when installed in the dash like that
Author:  bitingmidge [ Sun Apr 19, 2009 12:48 pm ]
Post subject:  Re: Aerial roof mount GV
ScrawnC wrote:
Yeah, very neat install!! I like the 4400 purely for the fact that it is din size, looks neat when installed in the dash like that


Yep. Trouble is, there's nowhere in the dash in the new model!

Cheers,

P
8O
Author:  BLZUK [ Sun Apr 19, 2009 7:45 pm ]
Post subject:  Re: Aerial roof mount GV
ScrawnC wrote:
Yeah, very neat install!! I like the 4400 purely for the fact that it is din size, looks neat when installed in the dash like that


Except thats a 4200 :P
Author:  gvzookdriver [ Sun Apr 19, 2009 11:09 pm ]
Post subject:  Re: Aerial roof mount GV
Thanks guys,
I should have said what i made it out of its made out of 3mm steel so its not going any where. i ran the cable through the rail then i went down through the roof now b4 you say anything bad yes i painted it with rust proof and then siliconed the crap out if it and guess what NO leaks yay
Author:  Scrawny [ Mon Apr 20, 2009 1:11 am ]
Post subject:  Re: Aerial roof mount GV
BLZUK wrote:
ScrawnC wrote:
Yeah, very neat install!! I like the 4400 purely for the fact that it is din size, looks neat when installed in the dash like that


Except thats a 4200 :P


:P Ok, so it was a bit hard to see in the small photo :P
Author:  just_cruizin [ Mon Apr 20, 2009 2:55 am ]
Post subject:  Re: Aerial roof mount GV
Where did you get the rail mount.
Author:  gvzookdriver [ Mon Apr 20, 2009 9:03 pm ]
Post subject:  Re: Aerial roof mount GV
well i got half the mount off ebay and made the rest myself the part that wraps around the rail i made and bent to suit but got this part off ebay

http://cgi.ebay.com.au/NAGOYA-RB-56-ant ... 240%3A1318

as you can see from the photo what i have made and what is the original part off ebay

hope this helps
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/