| auszookers.com https://auszookers.com/forum/ |
|
| Had an idea but probably not original! https://auszookers.com/forum/viewtopic.php?f=14&t=53004 |
Page 1 of 1 |
| Author: | paulh [ Mon Aug 15, 2016 8:28 pm ] |
| Post subject: | Had an idea but probably not original! |
Having shopped around the world via the internet for floor panels for my LJ80 and found them so expensive even without the shipping, I thought maybe I could cut the panels out of the rear floor area of a donor vehicle (not that I have a donor vehicle). Anybody tried this  Anybody have a donor vehicle?
|
|
| Author: | laurie [ Tue Aug 16, 2016 5:58 am ] |
| Post subject: | Re: Had an idea but probably not original! |
I have the rear floor out of a sierra for repair patches on the floor of my LJ ( but have not started yet ) profile looks like a good match |
|
| Author: | paulh [ Tue Aug 16, 2016 8:07 pm ] |
| Post subject: | Re: Had an idea but probably not original! |
Thanks Laurie I can expand my search. |
|
| Author: | barbender [ Fri Aug 19, 2016 9:43 pm ] |
| Post subject: | Re: Had an idea but probably not original! |
paulh wrote: Having shopped around the world via the internet for floor panels for my LJ80 and found them so expensive even without the shipping, I thought maybe I could cut the panels out of the rear floor area of a donor vehicle (not that I have a donor vehicle). Anybody tried this Anybody have a donor vehicle?If you can't find originals, look for an old time panel beater that uses "english wheels etc", most of these guys are retired now and for them it's pocket money (unless they do specialist restorations). I am sure they will be cheaper than imports. |
|
| Author: | Toomanycars [ Sat Aug 20, 2016 8:45 am ] |
| Post subject: | Re: Had an idea but probably not original! |
We cut the entire floor out and replaced it with checker plate.. |
|
| Author: | paulh [ Sun Aug 21, 2016 11:39 am ] |
| Post subject: | Re: Had an idea but probably not original! |
Thanks barbender and Toomanycars some other options. Thank you . |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|