| auszookers.com https://www.auszookers.com/forum/ |
|
| 3D printed bits https://www.auszookers.com/forum/viewtopic.php?f=14&t=57782 |
Page 1 of 1 |
| Author: | Joost [ Sat Nov 02, 2024 7:08 am ] |
| Post subject: | 3D printed bits |
Hi All. Normally I make WW2 1/10 scale RC models, but then it dawned on me that a Jimny is almost a 1/1 scale WW2 Jeep I know most people here do some epic things and this pales compared with that, but here are some small bits I made yesterday. Slowly I am converting my new Jimny to a (mini) overland vehicle and these are just small quality of life improvements. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|