| auszookers.com https://www.auszookers.com/forum/ |
|
| 6 point internal cage pics page 2 https://www.auszookers.com/forum/viewtopic.php?f=14&t=7584 |
Page 1 of 2 |
| Author: | zookster666 [ Thu Oct 29, 2009 12:22 am ] |
| Post subject: | 6 point internal cage pics page 2 |
I have been thinking of making a 6 point internal cage but not sure on how to go about the front section so post some pics of how you went about it where it runs and mounts etc I already have the rear hoop just unsure how to do tha "A" pillar section |
|
| Author: | Dee [ Thu Oct 29, 2009 5:10 pm ] |
| Post subject: | Re: 6 point internal cage |
Bent up 2 pieces that run foward to the corner of the windscreen, turn down at an angle to follow windscreen frame, and then bend again between the dash and door to go down to a mounting plate on te floor. I then bent & notched two spreader pieces, one at the top of the windscreen, one at the base above the dash. Dunno if you can see but u I also have door bars/braces going from the b pillar (at seat height) down to the base of the 'a pillar' bars. 
|
|
| Author: | Taff [ Thu Oct 29, 2009 7:36 pm ] |
| Post subject: | Re: 6 point internal cage |
I always wondered what you did with your seatbelts, thought you went to a 4pt harness or something. Looks awesome without the B pillar. |
|
| Author: | Dee [ Thu Oct 29, 2009 7:51 pm ] |
| Post subject: | Re: 6 point internal cage |
Taff wrote: I always wondered what you did with your seatbelts, thought you went to a 4pt harness or something.
Looks awesome without the B pillar. cheers yeah that was what i was aimin for with the half doors & all, no b pillar. |
|
| Author: | zookster666 [ Fri Oct 30, 2009 1:02 am ] |
| Post subject: | Re: 6 point internal cage |
thanks for that mate appreciate it |
|
| Author: | Taff [ Fri Oct 30, 2009 2:41 am ] |
| Post subject: | Re: 6 point internal cage |
You might need to dent your doors in a little bit to get the tube through. Mine is similar to dee's without the cross brace in the roof. |
|
| Author: | moose [ Sat Oct 31, 2009 7:17 pm ] |
| Post subject: | Re: 6 point internal cage |
Dee , can you take a pic of it going down the dash (a pillar leg) thanx |
|
| Author: | Dee [ Wed Nov 04, 2009 9:13 pm ] |
| Post subject: | Re: 6 point internal cage |
I'll try and get one this arv moosey 
|
|
| Author: | Dee [ Thu Nov 05, 2009 1:40 am ] |
| Post subject: | Re: 6 point internal cage |
these ok? |
|
| Author: | zookster666 [ Thu Nov 05, 2009 4:02 pm ] |
| Post subject: | Re: 6 point internal cage |
I started on my cage got both of the a pillar legs in do you have any problems with the doors not closing properly |
|
| Author: | Scrawny [ Thu Nov 05, 2009 4:05 pm ] |
| Post subject: | Re: 6 point internal cage |
zookster666 wrote: do you have any problems with the doors not closing properly
Mine needed a bit of encouragement to close. There was a thread on OL a while ago on cages wasn't there? Does anyone remember it? |
|
| Author: | Dee [ Fri Nov 06, 2009 12:24 pm ] |
| Post subject: | Re: 6 point internal cage |
yeah u will have probs with door clearance. When i made my half doors i narrowed them at the top/front to clear the cage. |
|
| Author: | zookster666 [ Sun Nov 08, 2009 8:48 pm ] |
| Post subject: | Re: 6 point internal cage |
I finished my cage today and fitted it I'm really happy with it besides the doors being a little stubborn to shut. And it's not as braced as yours Dee hope I never need it though lol. |
|
| Author: | fourby [ Sun Nov 08, 2009 8:49 pm ] |
| Post subject: | Re: 6 point internal cage |
Pics zoolster? |
|
| Author: | zookster666 [ Sun Nov 08, 2009 8:57 pm ] |
| Post subject: | Re: 6 point internal cage |
I will post some when the computer is fixed I'm using my iPhone at the moment |
|
| Author: | chef [ Thu Nov 12, 2009 12:18 pm ] |
| Post subject: | Re: 6 point internal cage |
so any pic yet??? |
|
| Author: | zookster666 [ Sat Nov 14, 2009 12:24 am ] |
| Post subject: | Re: 6 point internal cage |
will have some this weekend ,mate |
|
| Author: | zookster666 [ Sat Nov 14, 2009 9:08 pm ] |
| Post subject: | Re: 6 point internal cage |
here are pics as promised this is the best i have 
|
|
| Author: | steak_knife [ Sat Nov 14, 2009 9:10 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
Nice , now you have to get it plated!! |
|
| Author: | Scrawny [ Sat Nov 14, 2009 10:33 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
Do you have anything above the windscreen? |
|
| Author: | steak_knife [ Sat Nov 14, 2009 10:38 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
ScrawnC wrote: Do you have anything above the windscreen?
Yep have a closer look.
|
|
| Author: | zookster666 [ Sat Nov 14, 2009 10:47 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
Yeah there's a bar ontop of the windscreen I made it sit a little hight than it to so if it does go over the windscreen won't break I hope what do u mean I have to get it plated? |
|
| Author: | steak_knife [ Sat Nov 14, 2009 11:23 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
Blue plate, Mod plate, If Dot pull you up thay will want to see one. There are mobile engineer's that have a Qld trans ticket that can plate it for you. |
|
| Author: | zookster666 [ Sat Nov 14, 2009 11:57 pm ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
oh yeah getting that all sorted my boss can do blue plates. I still need to sort out the padding im just waiting for the off cuts of foam that we use on the cages we make. I cant see the point in buying it if were going to throw smaller pieces out. Ill put pics up when i do that to |
|
| Author: | steak_knife [ Sun Nov 15, 2009 12:06 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
zookster666 wrote: oh yeah getting that all sorted my boss can do blue plates. I still need to sort out the padding im just waiting for the off cuts of foam that we use on the cages we make. I cant see the point in buying it if were going to throw smaller pieces out.
Ill put pics up when i do that to I like you!!!!!!!  
|
|
| Author: | zookster666 [ Sun Nov 15, 2009 12:13 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
lol i like me to haha |
|
| Author: | jimbo_jones [ Sun Nov 15, 2009 3:45 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
zookster666 wrote: lol i like me to haha
the whore likes you 
|
|
| Author: | steak_knife [ Sun Nov 15, 2009 3:50 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
jimbo_jones wrote: zookster666 wrote: lol i like me to haha the whore likes you Your just jealous! peaceout 
|
|
| Author: | zookster666 [ Sun Nov 15, 2009 3:51 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
Someones gotta like me lol |
|
| Author: | steak_knife [ Sun Nov 15, 2009 4:02 am ] |
| Post subject: | Re: 6 point internal cage pics page 2 |
zookster666 wrote: Someones gotta lick window's with me lol
Fixed it for ya.
|
|
| Page 1 of 2 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|