auszookers.com
https://auszookers.com/forum/

Seat rails
https://auszookers.com/forum/viewtopic.php?f=37&t=39305		 Page 1 of 1
Author:  jonno_racing [ Thu Feb 28, 2013 3:34 pm ]
Post subject:  Seat rails
did suzuki change the seat rail's much in sierras?
will tin top 1ltr jobs fit my 90's widetrack?
Author:  tanshi [ Thu Feb 28, 2013 3:47 pm ]
Post subject:  Re: Seat rails
i think the fit. through out the leafy years. but yes they changed them alot
Author:  Blkfxx [ Thu Feb 28, 2013 4:30 pm ]
Post subject:  Re: Seat rails
I know that with my ute there are 2 different bolt holes for the rear of the rails, One in line with the rail and one offset.

However, With my dads WT it only has the ones inline with the rail.

IE I can't put my ute seats into the WT because they use the offset mount but I can fit the WT seats in my ute.
Author:  jonno_racing [ Thu Feb 28, 2013 7:23 pm ]
Post subject:  Re: Seat rails
Interesting.. what are the easiest ones to fit aftermarket seats to? i don't have any rails at all.
Author:  Gwagensteve [ Thu Feb 28, 2013 7:31 pm ]
Post subject:  Re: Seat rails
I think with some re drilling the driver's side rails from any sierra will fit any other (leaf) sierra. Nothing fits a doily. :D

I would say if you have sliders (i.e not fixed ute seats) then they will swap over. The passenger side won't - the front two bolts will line up, but new rear holes will need to be drilled to fit the hinge style 1.0 passenger side seat to a 1.3 floor.

Steve.
Author:  jonno_racing [ Fri Mar 01, 2013 7:38 am ]
Post subject:  Re: Seat rails
Ok no worries, so if i was to look for a set of rails what should i look for to make fitting of aftermarket seats nice and easy?
Author:  Blkfxx [ Fri Mar 01, 2013 5:27 pm ]
Post subject:  Re: Seat rails
Everything is the same width, Just different mount points on the floor.

So either way you go will be the amount of fab work.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/