| auszookers.com https://auszookers.com/forum/ |
|
| Rear wheel bearing - WT https://auszookers.com/forum/viewtopic.php?f=37&t=43778 |
Page 1 of 1 |
| Author: | smiley_666 [ Thu Nov 07, 2013 3:03 pm ] |
| Post subject: | Rear wheel bearing - WT |
So after a trip down to the Murray mouth and driving on a bit of a lean down the beach, the right rear wheel is covered with diff oil on the inside, and was dripping out by the time i stopped. Jacked it up when i got home and theres a bit of movement, so it'll need to be done. Whats the best way to do it? Genuine or just a bearing shop? Any part numbers to go off? Did try searching, but probably not well enough. Chears |
|
| Author: | scrubby [ Thu Nov 07, 2013 3:14 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
I just went to my bearing shop told them the car bang all done! |
|
| Author: | droverdave [ Thu Nov 07, 2013 4:20 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
You will need to press it on and off the axle though. |
|
| Author: | scrubby [ Thu Nov 07, 2013 4:26 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
I cut the outer race off the bearing smashed the guts out of the bearing then slid the tin cover off and the just knocked the rest off with a cold chisel.. (But I am a member of the RAG Engineering) |
|
| Author: | smiley_666 [ Thu Nov 07, 2013 4:51 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
no problem with doing it, have a press at work. Will try the bearing shop tomorrow, thanks |
|
| Author: | tanshi [ Thu Nov 07, 2013 4:55 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
make sure you get japanese bearings, not cheap chinese shit |
|
| Author: | want33s [ Thu Nov 07, 2013 6:24 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
If you have access to NT rear axles you can remove the bearings and keep the spacer rings. Fit them to your WT axles with new NT bearings and buy a box of beer with the savings over WT bearings. |
|
| Author: | klutched [ Fri Nov 08, 2013 7:47 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
tanshi wrote: make sure you get japanese bearings, not cheap chinese shit Is Koyo any good? |
|
| Author: | BlueSuzy [ Fri Nov 08, 2013 8:05 pm ] |
| Post subject: | Re: Rear wheel bearing - WT |
yep
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|