auszookers.com
https://auszookers.com/forum/

Baleno wiring loom removal.
https://auszookers.com/forum/viewtopic.php?f=37&t=43825
Page 1 of 1

Author:  frysie [ Sun Nov 10, 2013 7:40 pm ]
Post subject:  Baleno wiring loom removal.

Okay i got a bit of the loom (stuck behind the stupid air/con pipes and cant get it out so here is what I have... hopefully im not wasting my time trying to get it !!!

Engine loom (from the black fuse box) to inside dash
Image

from blue fuse box alongside passenger rail into the side (this is other side of the loom that I cant get out as its stuck while pulling form the drivers side!)
Image

under dash to the baleno tacho wiring
Image

from the gearbox all the way to back (lol i dont know why, but i did it to grab the fuel pump wiring
Image

The last of the mess I cant get out due to the wiring being stuck!! (most of this is for the black looking fuse box on drivers kick side panel
Image

The last of the loom stuck behind dash (cant get dash out for some reason) i cant see any bolts holding it down!!!
Image

The other side of the plugs and wiring im trying to pull through (that black zippy tie is allready cut)
Image


Do i need that bit of cable thats stuck? :(

Author:  want33s [ Mon Nov 11, 2013 6:46 am ]
Post subject:  Re: balno wiring loom noob question

To get the entire loom from the Baleno I wrecked, I removed the whole dash. Loom came out easily then.

Author:  azzas15 [ Mon Nov 11, 2013 7:43 am ]
Post subject:  Re: Baleno wiring loom removal.

I had trouble getting the dash out to... So out came the saw and tin snips and it was out quickly!!

Author:  frysie [ Mon Nov 11, 2013 7:50 am ]
Post subject:  Re: Baleno wiring loom removal.

Yes the sabre saw is getting a good work over tonight :D

Author:  azzas15 [ Mon Nov 11, 2013 9:37 am ]
Post subject:  Re: Baleno wiring loom removal.

Haha good work.

From memory there is a bolt either side near the door sill.

Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/