Hi i was just wondering how to take off a front shaft for a jimny i tryed un bolting the side that was connected to the transfer case but once i unbolted it i could not get it of the transfer case.
ANY TIPS??
| auszookers.com https://auszookers.com/forum/ |
|
| JIMNY front shaft https://auszookers.com/forum/viewtopic.php?f=37&t=43875 |
Page 1 of 1 |
| Author: | MikeyS [ Wed Nov 13, 2013 7:39 am ] |
| Post subject: | JIMNY front shaft |
Hi i was just wondering how to take off a front shaft for a jimny i tryed un bolting the side that was connected to the transfer case but once i unbolted it i could not get it of the transfer case. ANY TIPS??
|
|
| Author: | Blakey [ Wed Nov 13, 2013 7:55 am ] |
| Post subject: | Re: JIMNY front shaft |
are you pulling off the front driveshaft? if so once the bolts are off just bang it with a hammer lightly and it should pop off, its probably just rusted on to the lip of the flange. |
|
| Author: | MikeyS [ Wed Nov 13, 2013 7:59 am ] |
| Post subject: | Re: JIMNY front shaft |
yes the front drive shaft ok ill try that thanks Blakey. |
|
| Author: | Jezza86 [ Wed Nov 13, 2013 11:03 am ] |
| Post subject: | Re: JIMNY front shaft |
i used a screwdriver to part them but only because i generally smash things with hammers |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|