| auszookers.com https://auszookers.com/forum/ |
|
| Sierra Mixture Screw https://auszookers.com/forum/viewtopic.php?f=37&t=45965 |
Page 1 of 1 |
| Author: | maxtest [ Tue Apr 22, 2014 10:37 pm ] |
| Post subject: | Sierra Mixture Screw |
I think I need to adjust my mixture screw, someone played with it while it was off the car. Is there an easy way to pop the metal cap off it so the screw head is exposed? And is there a rough guide on setting the mixture like all the way in 2 turns back etc? Cheers |
|
| Author: | Marko_SJ [ Wed Apr 23, 2014 8:47 am ] |
| Post subject: | Re: Sierra Mixture Screw |
maxtest wrote: I think I need to adjust my mixture screw, someone played with it while it was off the car. Is there an easy way to pop the metal cap off it so the screw head is exposed? And is there a rough guide on setting the mixture like all the way in 2 turns back etc? Cheers You can buy the special tool, or cut the cap off. Instructions on how to set the idle are in the Factory Service Manual. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|