auszookers.com
https://auszookers.com/forum/

sj70 speedo
https://auszookers.com/forum/viewtopic.php?f=37&t=46287		 Page 1 of 1
Author:  pjtr17 [ Sun May 18, 2014 9:23 am ]
Post subject:  sj70 speedo
hey guys i replaced my snapped speedo cable a few weeks ago and i don't think its sitting properly in the transfer. i had my first drive of it yesterday no speedo until i just about got home and it worked for about 5 seconds. i removed the cable and tried turning it with it a screwdriver the wife said it was slightly moving?? is there something i'm missing is there a trick or something? any help or ideas greatly appreciated

cheers guys pat
Author:  Madhatter [ Mon May 19, 2014 7:23 pm ]
Post subject:  Re: sj70 speedo
Step 1: make sure cable is all the way home at BOTH ends. If this fails
Step 2 : pull off bottom end and put cordless dril on it.....speedo reads high, success box end is the failure.if not
Step 3: pull off speedo end, if you can't spin it speedo is the failure.
You'll probably find when you get both ends seated properly the problem will be gone
Author:  pjtr17 [ Tue May 20, 2014 6:43 am ]
Post subject:  Re: sj70 speedo
Righto I will try that one this afternoon thanks buddy :)
Author:  94_brad_wt [ Tue Jul 01, 2014 3:46 pm ]
Post subject:  Re: sj70 speedo
Hey guys just wondering if you have to take the dash claster apart to replace the cable
Cheers
Author:  Blkfxx [ Tue Jul 01, 2014 6:21 pm ]
Post subject:  Re: sj70 speedo
You don't have to take the cluster apart but you do have to pull the cluster out of the dash.
Author:  pjtr17 [ Fri Jul 11, 2014 6:13 pm ]
Post subject:  Re: sj70 speedo
Yea I removed the cluster to swap it over, apparently you don't really need to but I found it easier, I think it would be easier to drop the steering column as I broke the clips on my trying to remove it! Good luck
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/