auszookers.com
https://auszookers.com/forum/

removing body clips? [Jimny]
https://auszookers.com/forum/viewtopic.php?f=37&t=48452		 Page 1 of 1
Author:  GT_Tony [ Sun Nov 16, 2014 10:15 am ]
Post subject:  removing body clips? [Jimny]
is there a trick or secret to removing the body clips that hold the plastics on the Jimny?

some of them twist out. but others are a pain. want to check here before i get rough with them and most likely break them :roll:
Author:  tonyevans [ Sun Nov 16, 2014 10:48 am ]
Post subject:  Re: removing body clips? [Jimny]
If they are the double square ones like the Grand Vitara then they just pull out with care - they are genuine Suzuki parts and cot 4 dollars each.
Author:  jimny_timmy [ Mon Nov 17, 2014 4:41 pm ]
Post subject:  Re: removing body clips? [Jimny]
You can buy panel removal tools that are plastic and have an end on them kind of like a claw hammer. If you slip them in between the clip and panel they pop out. I presume you're talking about the ones on the doors?
Author:  GT_Tony [ Mon Nov 17, 2014 7:52 pm ]
Post subject:  Re: removing body clips? [Jimny]
jimny_timmy wrote:
You can buy panel removal tools that are plastic and have an end on them kind of like a claw hammer. If you slip them in between the clip and panel they pop out. I presume you're talking about the ones on the doors?



i got the ones on the doors by grinding a 10mm open spanner thin, with a slight bend (much like the tool you described) and that worked perfect. problem was the rear guards, where you cant get behind to push them out
Author:  Gromet [ Mon Nov 17, 2014 7:55 pm ]
Post subject:  Re: removing body clips? [Jimny]
some of them ones you need to push in the pin further then reset them when putting back in...
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/