| auszookers.com https://auszookers.com/forum/ |
|
| gearstick vibration https://auszookers.com/forum/viewtopic.php?f=37&t=49278 |
Page 1 of 1 |
| Author: | Jezza86 [ Mon Feb 09, 2015 3:58 pm ] |
| Post subject: | gearstick vibration |
In a manual, the gearstic vibrates because things are slightly out of balance. Correct? So if thats geting worse? Bearings? |
|
| Author: | alien [ Mon Feb 09, 2015 7:23 pm ] |
| Post subject: | Re: gearstick vibration |
Could be the rear engine mount is hardened / cracked? |
|
| Author: | Gwagensteve [ Mon Feb 09, 2015 8:16 pm ] |
| Post subject: | Re: gearstick vibration |
Uni joint. Shift sheet wear bent transfer mount and wot alien said. |
|
| Author: | Jezza86 [ Mon Feb 09, 2015 8:31 pm ] |
| Post subject: | Re: gearstick vibration |
Yep just at idle that I noticed it |
|
| Author: | DC3PTIKON [ Mon Feb 09, 2015 9:55 pm ] |
| Post subject: | Re: gearstick vibration |
What is your RPM at idle with engine at operating temp, no loads or A/C? Base idle out, dirty EGR/throttle valve or dodgey IAC motor maybe. |
|
| Author: | Jezza86 [ Tue Feb 10, 2015 7:37 am ] |
| Post subject: | Re: gearstick vibration |
RPM looks stable. have recently replaced the clutch at 28,000K as the bearings were dead because the car has been doing too much swimming. just looking for signs that my gearbox needs a rebuild |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|