| auszookers.com https://auszookers.com/forum/ |
|
| carby rebuild question https://auszookers.com/forum/viewtopic.php?f=37&t=50075 |
Page 1 of 1 |
| Author: | andrew [ Mon May 11, 2015 10:55 am ] |
| Post subject: | carby rebuild question |
Im rebuilding the carby on my sierra I bought in the hopes of Getting it to run. In the kit isnt much an accelerator pump amd a bunch of gaskets My question is do I need and gasket glues or sealers or anything or do I just put it together with what they have supplied ??? |
|
| Author: | Marko_SJ [ Mon May 11, 2015 4:52 pm ] |
| Post subject: | Re: carby rebuild question |
andrew wrote: Im rebuilding the carby on my sierra I bought in the hopes of Getting it to run. In the kit isnt much an accelerator pump amd a bunch of gaskets My question is do I need and gasket glues or sealers or anything or do I just put it together with what they have supplied ??? I don't think you're supposed to use goop on the carb gaskets due to the potential for it to degrade and get where it shouldn't. Use plenty of compressed air and carby cleaner, use a dip if you can get it. |
|
| Author: | andrew [ Mon May 11, 2015 6:32 pm ] |
| Post subject: | Re: carby rebuild question |
Yeah that's what I thought too. The Baker light bit seems a bit how ya going I wounder if I should replace it too As I'm fully not pulling it down again |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|