| auszookers.com https://auszookers.com/forum/ |
|
| RUF hasn't really increased my flex??? https://auszookers.com/forum/viewtopic.php?f=37&t=51170 |
Page 1 of 1 |
| Author: | bibby [ Mon Oct 12, 2015 10:48 am ] |
| Post subject: | RUF hasn't really increased my flex??? |
hey guys so just the other night I performed RUF drilling the perch 20mm back and using my already existing extended shackles! The rear springs in the front are made up of 4 springs the 3 main original ones and then the 3rd main one out the front pack that was taken out. I also only have 4 springs in the back with the longest load spring taken out. Doing the RUF made my shackle angle a lot better but when i tried to flex it out it made no difference to its original flex. I am also sourcing some mazda 323 spring for the Rear to give my rear shackles a better angle and have a longer spring. This has all been done to a 1985 NT long wheel base ute. Bear in mind it dose already have longer commy shocks installed, i will be taking them out and flexing it with a mates forklift tomorrow or today to see if that is the issue but i don't believe it is. Any ideas as to what it could be? From the floor to the underside of the tire (front left) when i flexxed it was only sitting about 400mm up, which compared to photos i have seen with RUF seems very minimal. Any help would be greatly appreciated Bibby |
|
| Author: | alien [ Mon Oct 12, 2015 11:13 am ] |
| Post subject: | Re: RUF hasn't really increased my flex??? |
Are you compressing the other side? Maybe the springs are a bit stiff? Getting the high side to compress is the key, not the drooped side to hang lower. Also, have a try with your shocks undone at one end in case they are the cause of your issue. |
|
| Author: | bibby [ Mon Oct 12, 2015 11:54 am ] |
| Post subject: | Re: RUF hasn't really increased my flex??? |
maybe i should take out the 4th spring in the front pack as the bottom 2 are lift springs. but yes i will make sure that the shocks are not the issue |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|