hey all i have no lift and 31s and alot of tyre rubbing! i want to chop my guards but i also want some advice on it due to i have never done it before? cheers all and tips and hints help
| auszookers.com https://auszookers.com/forum/ |
|
| hey guys need some with guard chops for a sierra https://auszookers.com/forum/viewtopic.php?f=37&t=52514 |
Page 1 of 1 |
| Author: | johnnymitchell01 [ Sat May 21, 2016 9:33 am ] |
| Post subject: | hey guys need some with guard chops for a sierra |
hey all i have no lift and 31s and alot of tyre rubbing! i want to chop my guards but i also want some advice on it due to i have never done it before? cheers all and tips and hints help
|
|
| Author: | Gwagensteve [ Sat May 21, 2016 10:59 am ] |
| Post subject: | Re: hey guys need some with guard chops for a sierra |
Have a good search for "virtual lift" - That's how it's commonly referred to on here. There are MANY different methods - from quick and rough to very, very time consuming and neat. |
|
| Author: | Gwagensteve [ Sat May 21, 2016 11:01 am ] |
| Post subject: | Re: hey guys need some with guard chops for a sierra |
I punched "virtual+lift sierra" into the search engine and got this thread straight away. viewtopic.php?f=5&t=34550&start=0 read this thread from start to finish heaps. viewtopic.php?f=5&t=52270 but there's heaps more. PS welcome to the board. |
|
| Author: | MrRocky [ Sat May 21, 2016 10:26 pm ] |
| Post subject: | Re: hey guys need some with guard chops for a sierra |
31"s fit in the arch pretty easy, redrilling your spring perches to move your diff 20mm forward, big hammer, rim offset and some decent bumpstops will likely negate the need for much if any chop. I run 32"s with only around 2" lift but i reckon i could easily drop that and still be ok.  . 
|
|
| Author: | Gwagensteve [ Sun May 22, 2016 2:17 pm ] |
| Post subject: | Re: hey guys need some with guard chops for a sierra |
that tyre is looking pretty tucked in there MrRocky - are you getting headlight bucket contact in that situation? Steve. |
|
| Author: | MrRocky [ Sun May 22, 2016 8:04 pm ] |
| Post subject: | Re: hey guys need some with guard chops for a sierra |
Nah i have given them a slight tap and they come very close but the stock lwb rear top spring seems to centralise the wheel perfectly in the wheel arch. Offset was super critical theres only a couple mm clearance in places, 50mm spacers in the rear and 35mm in the front, i tried a few other options but this is the only one that worked |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|