| auszookers.com https://auszookers.com/forum/ |
|
| leaking coolent 10fa https://auszookers.com/forum/viewtopic.php?f=37&t=52951 |
Page 1 of 1 |
| Author: | greavesyzook [ Wed Aug 10, 2016 3:18 pm ] |
| Post subject: | leaking coolent 10fa |
My 10fa motor just started leaking coolent from near the water pump... Iv decided to replace it Is it a hard job to do? Also doing timing belt is this easy? |
|
| Author: | Angus Martin [ Wed Aug 10, 2016 8:10 pm ] |
| Post subject: | Re: leaking coolent 10fa |
Neither are hard, just take a bit of time, before you take the timing belt off, mark where the cog sits, draw a line on the camshaft/crankshaft cog and continue it onto the block and line them up when you put the new belt on so you don't have to reset the timing |
|
| Author: | greavesyzook [ Wed Aug 10, 2016 9:00 pm ] |
| Post subject: | Re: leaking coolent 10fa |
Thanks Angus. that will help a lot |
|
| Author: | Angus Martin [ Thu Aug 11, 2016 4:42 pm ] |
| Post subject: | Re: leaking coolent 10fa |
No worries, hope it made sense |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|