| auszookers.com https://auszookers.com/forum/ |
|
| Help with locking washer https://auszookers.com/forum/viewtopic.php?f=37&t=53325 |
Page 1 of 1 |
| Author: | andrew [ Wed Oct 05, 2016 12:04 pm ] |
| Post subject: | Help with locking washer |
Hi, i was doing my front wheel beaings but lost the locking washer that goes between the wheel bearing and the 2 big nuts that lock together.. A) do i need it to stop the nuts being too tight on the wheel bearing and if so..b) does anyone know where i can find one. |
|
| Author: | bumstein [ Wed Oct 05, 2016 12:19 pm ] |
| Post subject: | Help with locking washer |
I wouldn't leave the lock washer off.. The torque settings aren't tight, if you over tighten them they will overheat and wear quickly! Try Covs, they have them sold separately for Landcruisers but would likely have to order them in for zooks |
|
| Author: | jdk81 [ Wed Oct 05, 2016 12:35 pm ] |
| Post subject: | Re: Help with locking washer |
How soon do you need one? I have a few in my box of bits. I can post it up of you pay for postage. Express would be best, regular mail here sucks arse, and can take ages. |
|
| Author: | andrew [ Wed Oct 05, 2016 8:54 pm ] |
| Post subject: | Re: Help with locking washer |
Pm sent jdk cheers |
|
| Author: | bumstein [ Wed Oct 05, 2016 9:47 pm ] |
| Post subject: | Re: Help with locking washer |
Oh hang on. Are you taking about the lock tabs which goes between the two wheel bearing nuts or the thrust washer that goes between the inner nut and the outer bearing? |
|
| Author: | andrew [ Thu Oct 06, 2016 9:49 am ] |
| Post subject: | Re: Help with locking washer |
Inner nut and outer bearing |
|
| Author: | Gwagensteve [ Thu Oct 06, 2016 10:48 am ] |
| Post subject: | Re: Help with locking washer |
You can't maintain bearing preload without it. |
|
| Author: | bumstein [ Thu Oct 06, 2016 1:28 pm ] |
| Post subject: | Re: Help with locking washer |
Thrust washer.. Different from the lock tab washer but still essential.. Either jdk81 has a pair or hit up Wreckers, eBay, Suzistore |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|