auszookers.com
https://auszookers.com/forum/

Me again
https://auszookers.com/forum/viewtopic.php?f=37&t=54203		 Page 1 of 1
Author:  cairns27 [ Mon May 01, 2017 3:05 pm ]
Post subject:  Me again
I noticed liquid on the inside of the rear wheel, fiqured it would be the wheel cylinder, pulled the hub off, but shit over everything, so I just degreased it, and put it back together. Drove out to the bitumin, and when back and forward, jumping on the brakes, hoping to adjust them up. Seemed to work. Was going to look for the leak in the morning, the cylinder was moist under the end caps. Fuck me the thing won't idle now, redlines easy.

What can be wrong ???? I played with both idle screws, no difference. Vac hoses seem good.

Thanking you in anticipation .

bye
Author:  greenzook89 [ Mon May 01, 2017 4:02 pm ]
Post subject:  Re: Me again
Idle jet blocked. Need to pull apart and clean.

Leak will either be axle seal or slave cylinder.

Sayonara.
Author:  cairns27 [ Mon May 01, 2017 4:26 pm ]
Post subject:  Re: Me again
Yeah, I haven't checked the diff level yet. I got a filter before the carby too. Pulling the carby apart is beyond me.

Could something really got in there.

The leak is the least of my problem, I'll drive it like this till I see what's wrong.

bye
Author:  bumstein [ Mon May 01, 2017 4:43 pm ]
Post subject:  Re: Me again
Checking the jets is pretty easy.

On the float bowl there's two large brass plugs. Undo them and get a flat head screw driver in to undo the jets. Might need to lift the float a little (undo one jet while lifting the float wth a screw driver in the other hole).

Easier than it sounds!!

Yes they get blocked.

Change all your fuel filters too
Author:  cairns27 [ Tue May 02, 2017 5:25 pm ]
Post subject:  Re: Me again
Like a bought one again. Glad I didn't f*#k with the carby, it fixed itself. tar

bye
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/