| auszookers.com https://auszookers.com/forum/ |
|
| Baleno engine lift points https://auszookers.com/forum/viewtopic.php?f=37&t=54327 |
Page 1 of 1 |
| Author: | davemcgrath [ Fri Jun 23, 2017 12:59 pm ] |
| Post subject: | Baleno engine lift points |
Another noob type question here. Where is the second Baleno engine lift point? I can only see 1, highlighted in purple below. I actually want to remove the engine minus the transmission if possible. The FSM only explains how to remove them both together. Assuming I just undo the transmission to engine connections and push them apart as I hoist out the engine. 
|
|
| Author: | Gwagensteve [ Fri Jun 23, 2017 1:33 pm ] |
| Post subject: | Re: Baleno engine lift points |
I just run a strap around the back of the head/ thermostat housing. It's not a heavy motor. |
|
| Author: | MrRocky [ Fri Jun 23, 2017 3:44 pm ] |
| Post subject: | Re: Baleno engine lift points |
I just double up a tiedown strap through the exhaust and inlet manifolds |
|
| Author: | davemcgrath [ Fri Jun 23, 2017 5:31 pm ] |
| Post subject: | Re: Baleno engine lift points |
I decided to remove one of the lift points from the sierra 1.3 block and then attached it to the inlet manifold on the Baleno. Seemed to hold pretty firm. Got it out and onto a pallet now! |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|