auszookers.com
https://auszookers.com/forum/

No aligment hole / dowel in Sierra G13BA flywheel
https://auszookers.com/forum/viewtopic.php?f=37&t=54332		 Page 1 of 1
Author:  davemcgrath [ Sat Jun 24, 2017 3:30 pm ]
Post subject:  No aligment hole / dowel in Sierra G13BA flywheel
Wondering why there is no alignment hole or dowel in my Sierra G13BA flywheel that I'm about to bolt on to the Baleno 1.6 crankshaft.
The Baleno crankshaft has an alignment hole.
Is it going to matter what orientation I install the flywheel?
Author:  Gwagensteve [ Sat Jun 24, 2017 6:05 pm ]
Post subject:  Re: No aligment hole / dowel in Sierra G13BA flywheel
No. Won't matter as far as I know.
Author:  davemcgrath [ Sat Jun 24, 2017 6:14 pm ]
Post subject:  Re: No aligment hole / dowel in Sierra G13BA flywheel
Sweet, thanks Steve.
Full steam ahead.
Unfortunately I broke the A/C compressor mount while I was removing the motor which will probably cause problems as that mount also holds the tensioner pulley onto the block.
I can't see a wrecker selling that off cheaply.
Probably going to have order new genuine. :x
I'll call Makin Luby parts for a quote on Monday.
Author:  Gwagensteve [ Sat Jun 24, 2017 7:11 pm ]
Post subject:  Re: No aligment hole / dowel in Sierra G13BA flywheel
The baleno A/C bracket won't clear the chassis of the sierra IIRC.
Author:  MrRocky [ Sat Jun 24, 2017 7:41 pm ]
Post subject:  Re: No aligment hole / dowel in Sierra G13BA flywheel
Ac is able to be removed from the baleno motor with zero issues to the running of the motor.
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/