| auszookers.com https://auszookers.com/forum/ |
|
| Baleno water inlet pipe removal (without removing pump) https://auszookers.com/forum/viewtopic.php?f=37&t=54339 |
Page 1 of 1 |
| Author: | davemcgrath [ Mon Jun 26, 2017 7:09 pm ] |
| Post subject: | Baleno water inlet pipe removal (without removing pump) |
Wondering if I can get this water inlet pipe off (pipe coming off the rear of the pump) without removing the water pump? ![]() Is it possible? |
|
| Author: | Blkfxx [ Mon Jun 26, 2017 7:43 pm ] |
| Post subject: | Re: Baleno water inlet pipe removal (without removing pump) |
Should just slide out once you remove any bolts securing it to the block. |
|
| Author: | Gwagensteve [ Mon Jun 26, 2017 7:55 pm ] |
| Post subject: | Re: Baleno water inlet pipe removal (without removing pump) |
Yep. Defo. |
|
| Author: | MrRocky [ Mon Jun 26, 2017 8:29 pm ] |
| Post subject: | Re: Baleno water inlet pipe removal (without removing pump) |
Remove 10mm bolt, eat some weetbix, yank it out |
|
| Author: | davemcgrath [ Tue Jun 27, 2017 5:22 pm ] |
| Post subject: | Re: Baleno water inlet pipe removal (without removing pump) |
thx, it just needed a good few hits with a hammer to come out. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|