| auszookers.com https://auszookers.com/forum/ |
|
| transfer case stuck in neutral https://auszookers.com/forum/viewtopic.php?f=37&t=54603 |
Page 1 of 1 |
| Author: | nickireland1 [ Wed Sep 20, 2017 4:36 pm ] |
| Post subject: | transfer case stuck in neutral |
Hi people, I'm sure this has been done before but my sj50 transfer case is stuck in neutral. It hasnt been driven in a while and when I tried to go from 2h to 4l it got stuck in n and wont budge. the stick can be wobbled and it has been a bit sloppy and difficult to change for a while. i have tried turning the shafts and such to no effect. what can I do? |
|
| Author: | Bruce [ Wed Sep 20, 2017 5:19 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
Pull the stick out and replace the polyurethane bush. |
|
| Author: | nickireland1 [ Wed Sep 20, 2017 7:37 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
cheers il do that and see. can i get one from bursons or repco? or should i just ebay it? |
|
| Author: | just_cruizin [ Wed Sep 20, 2017 8:26 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
We can supply a replace bush and the tool to remove the shifter whilst it's in the vehicle. |
|
| Author: | nickireland1 [ Wed Sep 20, 2017 9:37 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
whats the damage? |
|
| Author: | just_cruizin [ Thu Sep 21, 2017 7:29 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
$25 plus post |
|
| Author: | shep [ Thu Sep 21, 2017 9:50 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
Or buy a bush from the AZ shop |
|
| Author: | cairns27 [ Fri Sep 22, 2017 12:02 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
Does the tool find neutral before you put the new stick and bush in. I remember it being a shitfight finding it with two screwdrivers. bye |
|
| Author: | just_cruizin [ Sat Sep 23, 2017 3:36 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
No, pull the lever up and then move it to neutral |
|
| Author: | dylanwilliams [ Sun Sep 24, 2017 6:29 am ] |
| Post subject: | Re: transfer case stuck in neutral |
I thought you were ment to line the slots in the shift rods up to re install the shifter and new bushing. Which is 4 high not neutral? |
|
| Author: | Technotron101 [ Wed Oct 04, 2017 2:19 pm ] |
| Post subject: | Re: transfer case stuck in neutral |
That's how I always get shifters in and out. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|