| auszookers.com https://auszookers.com/forum/ |
|
| Engine height https://auszookers.com/forum/viewtopic.php?f=37&t=55071 |
Page 1 of 1 |
| Author: | MrRocky [ Wed Mar 14, 2018 7:30 am ] |
| Post subject: | Engine height |
Bit of a stretch but does anyone have a m13 jimny and baleno/g13bb engine they could measure the height of for me with a reasonable degree of accuracy from lowest point to highest. Also after different sump configurations available on m series engines including fwd applications. Thinking i might try stuff one in the lj Cheers |
|
| Author: | greyghost [ Wed Mar 14, 2018 8:45 am ] |
| Post subject: | Re: Engine height |
the M will fit into an LJ ok, but its friggin tight.It's made a lot easier if you have an 80 hood. I bough a M-Jimny a few months ago for this exact reason, to go into my LJ50. lots of measurements later and its tight as. the G will fit similarly but you cant use a Vit injection as the cross over pipe will foul the hood. all the others should be ok, but the G is a little taller that the M (possibly 50mm) |
|
| Author: | MrRocky [ Wed Mar 14, 2018 8:50 am ] |
| Post subject: | Re: Engine height |
Yeah mine is an 80, the remote shifter location and m15/18 upgrade appeals to me. Ive only seen g16 done with body lifts. Sump vs front diff pumpkin is my next concern. Tbh mine isnt for offroad i have a spare diff here id consider chopping the pumpkin flat and only being 2wd for efi and 5spd |
|
| Author: | greyghost [ Wed Mar 14, 2018 10:42 am ] |
| Post subject: | Re: Engine height |
id swap in 1L off housings first |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|