[shane1992]

Ok so All the bolts are out, One of the CV's have been undone, Is there anything else that needs to be done? I just flipped it and started throwing shit from sitting in the sun trying to pull it out, It comes apart by a couple of mm's. I just dont want to damage then internals if I pull any harder....

Also do you have to take the axles out of the bacck diff completely?

All new to this kind of stuff

Cheers

[christover1]

have you removed the inner axle, inside the axle housing?
It wont pull out without doing that.

[shane1992]

Lol that explains it. Thanks

[christover1]

rear axles only need sliding out far ebnough to clear diff centre.
But best to pull them all the way,
check splines and bearings etc while its apart