[want33s]

As above...
What is the torque setting for the cam retainer bolts on a G16B head (1.6 16V) ?
Thanks
Jas.

[losfer]

i have a special torque wrench as a standard one will not go that low , i set them to 9=11 INCH/LB

[Scrawny]

So bugger all!

[want33s]

Thanks guys.. Job's done now.

[Damo]

Jase out of interest what did the journals in the head look like? The ones on my spare head have big f*ck off gouges in them

[want33s]

Damo wrote:

Jase out of interest what did the journals in the head look like? The ones on my spare head have big f*ck off gouges in them

There were a few little scratches but nothing to be too concerned about.. Shame they don't run bearings for the cam.

[Damo]

want33s wrote:

There were a few little scratches but nothing to be too concerned about.. Shame they don't run bearings for the cam.

That's for sure, but I guess the load those journals would see isn't anything like the crank bearings.