[matfan]

Hi All,

Does anyone know what brand of extractors fit a sierra with the 1.6 petroworks kit installed? I currently have Lukey extractors but they've been bashed to fit it and they're pretty rusty anyway. Any help would be appreciated.

Cheers
Matt

[Chop]

Do the lukey hit the chassis? Mine did when I put the g16A in mine, so I got them modified and that didn't cost much.

[matfan]

Not sure, the engine isn't in the car yet. There is a bashed-in spot just below the lukey badge that the previous owner must have done to make it fit. Like I said, it's rusty anyway so I think it's time for a new set. I was looking at the Doug Thorley tri-y extractors but I'd love to know if a set exists that doesn't require modification.

[atari4x4]

MPH do a header to suit the 1.6 into a Sierra, NFI if it works with the petroworks kit though... plenty of info on here about MPH headers.

[matfan]

Yeah the petroworks kit has the engine sitting a hell of a lot lower in between the rails than any of the other kits. I've spoken to Petroworks and they tell me that in the states the thorley 716y headers work with the US delivered Samurai with the 16v conversion so I'll get the engine in and take some measurements and I'll report back when I find the solution.
Cheers for the help guys.