[slowsierra]

hi guys

now the LWB build is just about finished. i have the time to look at engine set ups. the engine in it now is a G13A (standard sierra engine) with low compression pistons ect. not too sure what it has exactly in it as i brought the engine like that but thats all i remember. i also have a head from a G16A (vitara) with TBI. my plans are to fit the tbi to the g13a and run a small turbo on it. i don't want stupid power just to help it get up to speed when loaded up with camping gear and a trailer ect. i know a lot of people will say forget it, just put a g16b in it and i tend to agree but this what i have so i would like to get it to work.

i haven't really started pulling everything apart yet as i am not to sure what i need and what i don't (wiring and sensors ect. feel free to advise me) and the tbi head was all disconnect when i got too which makes it harder. so to start the questions.

will the g16a intake manifold bolt to the g13a? or will i have to make up a adaptor plate to bolt the TBI to where the carby is?




TBI head and wiring couple of things plugged in


top view of TBI


front of TBI


side view of TBI


back side of TBI


otherside of TBI