sounds like your brushes are worn out!!
| auszookers.com https://auszookers.com/forum/ |
|
| winch not working https://auszookers.com/forum/viewtopic.php?f=5&t=10049 |
Page 1 of 1 |
| Author: | Ridge [ Tue Feb 23, 2010 4:41 pm ] |
| Post subject: | winch not working |
i have a tmax 9000lb winch and it is not working anymore. i have checked the earth, and cleaned up the contacts. checked all wiring from battery to the isolator, and tested the control box. there is power going to the box when i try and get it to wind in / out but nothing happens. I opened up the control box and it was pretty clean except for dust, i was expecting water or mud to be in it. i am pretty sure that the problem is with the motor. the clutch seems to shift fine from in to out. any ideas before i pull it apart? |
|
| Author: | squirezook [ Tue Feb 23, 2010 5:00 pm ] |
| Post subject: | Re: winch not working |
It may be lightly seized Give it a crack with a hammer while hitting the switch . |
|
| Author: | Coffszook [ Tue Feb 23, 2010 10:29 pm ] |
| Post subject: | Re: winch not working |
sounds like your brushes are worn out!!
|
|
| Author: | ajsr [ Tue Feb 23, 2010 11:31 pm ] |
| Post subject: | Re: winch not working |
is the power coming out of the control box? will the winch spin if you by pass the box? |
|
| Author: | DMAC [ Wed Feb 24, 2010 12:12 am ] |
| Post subject: | Re: winch not working |
ajsr wrote: is the power coming out of the control box?
will the winch spin if you by pass the box? x2 Solenoid pulling in? Volts on the load side of the solenoids? |
|
| Author: | Ridge [ Wed Feb 24, 2010 4:05 am ] |
| Post subject: | Re: winch not working |
DMAC wrote: ajsr wrote: is the power coming out of the control box? will the winch spin if you by pass the box? x2 Solenoid pulling in? Volts on the load side of the solenoids? I have not tested the winch motor yet to see if power is getting to it. there is definatly power to the control box, but the winch wont wind in the 15m of cable i have wraped around my bar  It is only a year old and has only had light use, if that makes a difference. How would you by pass the box?
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|