| auszookers.com https://auszookers.com/forum/ |
|
| Replacing Clutch on Sierra https://auszookers.com/forum/viewtopic.php?f=5&t=10076 |
Page 1 of 1 |
| Author: | New2zookies [ Wed Feb 24, 2010 8:39 pm ] |
| Post subject: | Replacing Clutch on Sierra |
I am in the process of rebuilding my 1.3l G13A engine and I am at the stage of replacing the clutch plate and pressure plate. Is there any way of doing this without the need for the alignment tool (illustrated in the manual). I understand I have to keep the clutch plate aligned as I do up the bolts on the pressure plate ?????? |
|
| Author: | Taff [ Wed Feb 24, 2010 8:50 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
just go by eye and feel if your confident. If not get a broomstick and wrap it in tape til its a good fit. I never used an alignment tool to do mine. |
|
| Author: | eldo [ Wed Feb 24, 2010 8:56 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
i have used a socket extension and done it by eye, never missed yet |
|
| Author: | MrRocky [ Wed Feb 24, 2010 9:23 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
i normally pull motor and box out as one and do the rear main and g/box seal while im at it. Only cause its a pain to do if you dont have a hoist or someone to help. |
|
| Author: | New2zookies [ Wed Feb 24, 2010 9:54 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
Thanks guys will try those ideas tonight |
|
| Author: | shadowman55 [ Wed Feb 24, 2010 9:59 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
I did mine by myself by eye, only took me two attempts to get it to line up Sam |
|
| Author: | New2zookies [ Thu Feb 25, 2010 3:31 pm ] |
| Post subject: | Re: Replacing Clutch on Sierra |
Tried the long socket idea, worked fine, thanks Eldo. She started first time after bottom end rebuild aswell, when I finally connected all leads to the ignition coil correctly, lol  Just needs a bit of fine tuning now. Did notice the Thrust/release bearing is still noisy even with new one installed???
|
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|