| auszookers.com https://auszookers.com/forum/ |
|
| Heater tap https://auszookers.com/forum/viewtopic.php?f=5&t=10182 |
Page 1 of 1 |
| Author: | jonno_racing [ Wed Mar 03, 2010 11:42 pm ] |
| Post subject: | Heater tap |
ok i have had nothing but issues with heater taps.. and the hoses that lead to them.. i am currently thinking of replacing it all with brand new taps and a brand new ball valve so i KNOW it is going to work fine.. any ideas? should i stick with the heater tap? am i doing it wrong? |
|
| Author: | coneykid [ Thu Mar 04, 2010 2:21 am ] |
| Post subject: | Re: Heater tap |
no way. get rid of ya heater tap. i an Auto elec and i am always fitting ball valves in place of heater taps. but this is Queensland. they dont get turned on so much here. its all about air con.. |
|
| Author: | want33s [ Thu Mar 04, 2010 2:46 am ] |
| Post subject: | Re: Heater tap |
jonno_racing wrote: ok i have had nothing but issues with heater taps.. and the hoses that lead to them..
i am currently thinking of replacing it all with brand new taps and a brand new ball valve so i KNOW it is going to work fine.. any ideas? should i stick with the heater tap? am i doing it wrong? Thought you packed up your bat and ball and went home...... Anyway.... Heater taps VERY RARELY give ANY dramas... Just replace it and forget about it. |
|
| Author: | v.w.dave [ Thu Mar 04, 2010 6:05 am ] |
| Post subject: | Re: Heater tap |
want33s wrote: jonno_racing wrote: ok i have had nothing but issues with heater taps.. and the hoses that lead to them.. i am currently thinking of replacing it all with brand new taps and a brand new ball valve so i KNOW it is going to work fine.. any ideas? should i stick with the heater tap? am i doing it wrong? Thought you packed up your bat and ball and went home...... Anyway.... Heater taps VERY RARELY give ANY dramas... Just replace it and forget about it. |
|
| Author: | Damo [ Thu Mar 04, 2010 12:54 pm ] |
| Post subject: | Re: Heater tap |
v.w.dave wrote: want33s wrote: jonno_racing wrote: ok i have had nothing but issues with heater taps.. and the hoses that lead to them.. i am currently thinking of replacing it all with brand new taps and a brand new ball valve so i KNOW it is going to work fine.. any ideas? should i stick with the heater tap? am i doing it wrong? Thought you packed up your bat and ball and went home...... Anyway.... Heater taps VERY RARELY give ANY dramas... Just replace it and forget about it. Please don't clog up tech with non-tech related comments. Jonno, I think if you replaced the tap and put new hoses on you should be good. I too haven't had roblems with heater taps. Hoses on the other hand, I have had dramas with but that could have been avoided by routinely inspecting and replacing when necessary. |
|
| Author: | royce [ Thu Mar 04, 2010 1:14 pm ] |
| Post subject: | Re: Heater tap |
the taps will seize up if they get clogged in mud a lot, a good spray of inox or something normally keeps em good up here in qld I have many a time had some kind of non car tap in there and open the bonnet and leave it on for the 1 month a year you need a heater then shut it off the rest of the time 
|
|
| Author: | Rockhopper [ Sat Mar 06, 2010 11:21 am ] |
| Post subject: | Re: Heater tap |
My heater tap does'nt shut off the water flow properly so the heat is always on when the fresh air is switched on. Will buy a new tap one day (when I get all my bills under friggin control), but the ball valve is a good idea |
|
| Author: | jonno_racing [ Sat Mar 06, 2010 1:56 pm ] |
| Post subject: | Re: Heater tap |
to be honest the old heater tap was stuck on 2.. i am defendant thinking a ball valve, it is starting to get cold down here again, and i will want it on 24/7. and i KNOW a good quality ball valve wont fuck up and cost me my motor... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|