| auszookers.com https://auszookers.com/forum/ |
|
| 1.6 sierra powersteering belt size https://auszookers.com/forum/viewtopic.php?f=5&t=10267 |
Page 1 of 1 |
| Author: | brendan [ Sun Mar 07, 2010 9:30 pm ] |
| Post subject: | 1.6 sierra powersteering belt size |
anyone done this before, what belt did you use? engine is 1.6 efi form a vit |
|
| Author: | Rusho [ Sun Mar 07, 2010 9:50 pm ] |
| Post subject: | Re: 1.6 sierra powersteering belt size |
Couldn't you wrap a piece of string around it and measure it to get an estimate on size? Then match a belt up at ripco or supercrap? Just a thought, I'm sure someone will give younthe exact belt, but if all else fails. |
|
| Author: | brendan [ Sun Mar 07, 2010 9:54 pm ] |
| Post subject: | Re: 1.6 sierra powersteering belt size |
that was a last resor |
|
| Author: | BlueSuzy [ Sun Mar 07, 2010 9:59 pm ] |
| Post subject: | Re: 1.6 sierra powersteering belt size |
That is going to have to be the 1st resort! Your getting a jimny M13 ps pump. So, unsure what pulley it is, whether its different to vit, i dont know. Your just going to have to mount it, Then figure it out! |
|
| Author: | ninjadaniel [ Sun Mar 07, 2010 10:20 pm ] |
| Post subject: | Re: 1.6 sierra powersteering belt size |
4pk820...ish |
|
| Author: | BlueSuzy [ Mon Mar 08, 2010 5:16 pm ] |
| Post subject: | Re: 1.6 sierra powersteering belt size |
That size belt will be with the aircon. The jimny M13a with ps and ac was a 920. My vit ps on baleno motor runs same belt as baleno water/alt belt. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|