| auszookers.com https://auszookers.com/forum/ |
|
| somethings twisted/bent https://auszookers.com/forum/viewtopic.php?f=5&t=10483 |
Page 1 of 1 |
| Author: | BUZOOKA [ Wed Mar 17, 2010 1:51 am ] |
| Post subject: | somethings twisted/bent |
ok first noticed this when i had the 31s on the rear that the diff sits 2 the left about an inch not really sure wat i could be im thinking maby a bent hanger but it seems to handle fine plz help |
|
| Author: | coneykid [ Wed Mar 17, 2010 1:58 am ] |
| Post subject: | Re: somethings twisted/bent |
mine dose it to. but i think mine is due to 2 inch shackel lift |
|
| Author: | BUZOOKA [ Wed Mar 17, 2010 2:01 am ] |
| Post subject: | Re: somethings twisted/bent |
yer mines alll standard so that aint it butm could still eb hanger/shackel |
|
| Author: | OMalley [ Wed Mar 17, 2010 2:03 am ] |
| Post subject: | Re: somethings twisted/bent |
Mine does it too, both on the front and rear. But i have a dodgy shackle on the front. |
|
| Author: | Highway-Star [ Wed Mar 17, 2010 2:05 am ] |
| Post subject: | Re: somethings twisted/bent |
Poor rear axle manufacturing tolerances? My widetrack has a rear axle that measures somewhere between narrow track and widetrack. Can visually see that the rear is narrower than the front just quickly looking at my car, as its a good 20 or 30mm under length. Its also slightly offset to one side (can't remember which now, but its only about 5mm). Not as bad as Hiluxes which seem to notoriously have different wheelbases on each side of the vehicle If it bugs you too bad, find another axle, and measure it up before you buy it, then swap it in. I've personally been driving my car for over 5 years now, and it has not bothered me at all |
|
| Author: | BUZOOKA [ Wed Mar 17, 2010 2:08 am ] |
| Post subject: | Re: somethings twisted/bent |
o ok well if its just a common fualt then it doesnt worrie me so much i just thought it was something twisted or stuffed that's all cheers highway star P.s if any one else could come forward and give me a confirmation or a different diagnosis im more then happy to listen cheers luke |
|
| Author: | steak_knife [ Wed Mar 17, 2010 2:15 am ] |
| Post subject: | Re: somethings twisted/bent |
BUZOOKA wrote: o ok well if its just a common fualt then it doesnt worrie me so much i just thought it was something twisted or stuffed that's all
cheers highway star P.s if any one else could come forward and give me a confirmation or a different diagnosis im more then happy to listen cheers luke Suzuki's don't have fault's, thay have blemishes. |
|
| Author: | royce [ Wed Mar 17, 2010 2:31 am ] |
| Post subject: | Re: somethings twisted/bent |
Character, the word is character |
|
| Author: | steak_knife [ Wed Mar 17, 2010 2:36 am ] |
| Post subject: | Re: somethings twisted/bent |
royce wrote: Character, the word is character
Yes boss!!! |
|
| Author: | Highway-Star [ Wed Mar 17, 2010 2:40 am ] |
| Post subject: | Re: somethings twisted/bent |
Makes them all individuals |
|
| Author: | steak_knife [ Wed Mar 17, 2010 2:45 am ] |
| Post subject: | Re: somethings twisted/bent |
Highway-Star wrote: Makes them all individuals
Just like me, me ,me ,me, me, me & me!! |
|
| Author: | shandy92 [ Wed Mar 17, 2010 2:47 am ] |
| Post subject: | Re: somethings twisted/bent |
i no this is probably different, but i have this on the rear of my vitara. one side sticks out by about 15-20mm and the other side is in by 15-20mm. just stock vitara but with 235/75/15 on sunnies. it was the same on my last vitara with same setup. u cant really notice it tho as i have flares Mitch |
|
| Author: | steak_knife [ Wed Mar 17, 2010 8:16 am ] |
| Post subject: | Re: somethings twisted/bent |
On a vit I would be looking for worn bush's or movement in the center hemi joint, 10-15mm is not a lot tho. |
|
| Author: | bron5on [ Wed Mar 17, 2010 11:36 am ] |
| Post subject: | Re: somethings twisted/bent |
Yep, noticed my wheels stuck out a bit when I first did my lift and tyres. Even more so when I added shackles to the equation. Worried me at first but seems to be a common thing. |
|
| Author: | JrZook [ Wed Mar 17, 2010 2:43 pm ] |
| Post subject: | Re: somethings twisted/bent |
BUZOOKA wrote: ok first noticed this when i had the 31s on the rear that the diff sits 2 the left about an inch not really sure wat i could be
im thinking maby a bent hanger but it seems to handle fine plz help Where are you referencing it from? The body? Is it straight? Im assuming that all your rims are the same as well ie offset. Dan |
|
| Author: | 89_tintop [ Wed Mar 17, 2010 10:27 pm ] |
| Post subject: | Re: somethings twisted/bent |
my sierra also sticks out.. but i am sitting on sagged rims on the drivers side.. if you jack the chassis up till it sits all nice and even then the wheels sit equally out of the guards its all a visual thing. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|