| auszookers.com https://auszookers.com/forum/ |
|
| 1.3 swift engine https://auszookers.com/forum/viewtopic.php?f=5&t=1064 |
Page 1 of 1 |
| Author: | fenton [ Wed Jun 13, 2007 10:20 am ] |
| Post subject: | 1.3 swift engine |
Hey guys. I can get hold of a cheap fuel injected swift engine. Will this bolt straight into my sierra? I know it will have to be wired up ect but is it an easy conversion? Cheers |
|
| Author: | TZAR [ Wed Jun 13, 2007 9:40 pm ] |
| Post subject: | Re: 1.3 swift engine |
yes it will BUT you will have to modify the dizzy as it sticks straight out the back of the motor. Either cut a hole in the firewall of pay $400 for a right angle adapter from suzisport |
|
| Author: | CairnsZook [ Wed Jun 13, 2007 10:22 pm ] |
| Post subject: | Re: 1.3 swift engine |
Any legal issues with cutting through your firewall? |
|
| Author: | fenton [ Thu Jun 14, 2007 10:21 am ] |
| Post subject: | Re: 1.3 swift engine |
So other than the dizzy its a straight forward bolt in job? |
|
| Author: | fenton [ Thu Jun 14, 2007 10:44 am ] |
| Post subject: | Re: 1.3 swift engine |
what about a G13b head? Will this bolt straight onto my current block? |
|
| Author: | MART [ Sun Jun 17, 2007 1:03 am ] |
| Post subject: | Re: 1.3 swift engine |
To fit a G13b in your zuk you need to change parts from one motor to the other , Sump , Oil pickup , Camshaft , Distributor , or you could swap whole head , but EFI manifold might be different , what model swift and multi or single point EFI , Cheers Paul. |
|
| Author: | oscar [ Sun Jun 17, 2007 1:30 pm ] |
| Post subject: | Re: 1.3 swift engine |
yeh i was gonna do the same with my 16v swift but ended up gonna be to much work so i couldn't be blowed |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|