| auszookers.com https://auszookers.com/forum/ |
|
| hole in the top side on my trans box https://auszookers.com/forum/viewtopic.php?f=5&t=10703 |
Page 1 of 1 |
| Author: | jacca [ Sat Mar 27, 2010 8:04 pm ] |
| Post subject: | hole in the top side on my trans box |
I was cleaning the engine bay and noticed a hole in the trans box about the size of a 20 cent piece is it suppose to be there |
|
| Author: | Scrawny [ Sat Mar 27, 2010 8:08 pm ] |
| Post subject: | Re: hole in the top side on my trans box |
What type of vehicle? Does it go right through or is it blanked off? Do you have pics? I would suggest it's probably just a casting for something that isn't used on your model. Just re-read your post  
It goes through to the flywheel? It's for checking the ignition timing and comes with a rubber bung that fits in it. |
|
| Author: | PJ.zook [ Sat Mar 27, 2010 9:12 pm ] |
| Post subject: | Re: hole in the top side on my trans box |
Heh yeh ScrawnC had to reread a few times too, i take it he means transMISSION not transFER. If its transmission than thats normal, if its transfer than youre in trouble. |
|
| Author: | Scrawny [ Sat Mar 27, 2010 9:22 pm ] |
| Post subject: | Re: hole in the top side on my trans box |
PJ.zook wrote: Heh yeh ScrawnC had to reread a few times too, i take it he means transMISSION not transFER. If its transmission than thats normal, if its transfer than youre in trouble.
That's where I ran into trouble as I'm usually just skim reading
|
|
| Author: | 303zuke [ Sun Mar 28, 2010 4:59 am ] |
| Post subject: | Re: hole in the top side on my trans box |
There is a hole in the left side of the bellhousing on Sierras and LJs that is the inspection hole for the ignition timing mark on the flywheel. There should be a rubber plug to fill the hole, but they sometimes get lost. |
|
| Author: | jacca [ Sun Mar 28, 2010 5:42 pm ] |
| Post subject: | Re: hole in the top side on my trans box |
could that be why the clutch in not engaging because i had it submurged in mud could it be slipping on sumthing that has gotten into the clutch or flywheel |
|
| Author: | Ben_Sierra [ Sun Mar 28, 2010 11:37 pm ] |
| Post subject: | Re: hole in the top side on my trans box |
Could well be.... |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|