| auszookers.com https://auszookers.com/forum/ |
|
| Jimny rear seats https://auszookers.com/forum/viewtopic.php?f=5&t=10845 |
Page 1 of 1 |
| Author: | Benz [ Sat Apr 03, 2010 9:38 pm ] |
| Post subject: | Jimny rear seats |
have taken them out and replaced them with a flat board. need to now get rid of the stupid bolts that stick out from each side. anyone know if they are welded or bolted in??? |
|
| Author: | Benz [ Sat Apr 03, 2010 10:47 pm ] |
| Post subject: | Re: Jimny rear seats |
welded =[ man its dusty in there! |
|
| Author: | lordviper556 [ Sun Apr 04, 2010 12:12 am ] |
| Post subject: | Re: Jimny rear seats |
i removed mine as well loked at the bolt and was like hmm if i take it out i can put them back in if i want. i just left it she be right. just need to make up a board and put my tool box in. |
|
| Author: | Benz [ Sun Apr 04, 2010 12:58 am ] |
| Post subject: | Re: Jimny rear seats |
but i need all the space i can get! i'm going to cut them out.... man i hope i don't regret this |
|
| Author: | vermin [ Sun Apr 04, 2010 3:54 am ] |
| Post subject: | Re: Jimny rear seats |
I wouldn't cut em...I have just left mine there - may be a different story when I put storage drawers in though. |
|
| Author: | squizzytaylor [ Sun Apr 04, 2010 2:10 pm ] |
| Post subject: | Re: Jimny rear seats |
Id leave them, if you ever decide to sell the car a 4 seater is probably going to be a lot more appealing than a 2 seater. Geoff |
|
| Author: | alien [ Sun Apr 04, 2010 2:51 pm ] |
| Post subject: | Re: Jimny rear seats |
could you take off the spot welds on the bracket the bolt is welded to? that way if you need to go back to 4 seats you can re-weld the whole bracket on... |
|
| Author: | Benz [ Sun Apr 04, 2010 4:02 pm ] |
| Post subject: | Re: Jimny rear seats |
haha knowing me i will cut a big hole in the car..... |
|
| Author: | watermouse [ Mon Apr 05, 2010 3:27 pm ] |
| Post subject: | Re: Jimny rear seats |
I left mine on and used them to bolt some metal loops there to help secure loads. If you want to cut them off make some kind of jig or pattern before you do, so you can weld them back on in the same place should you want to reverse the process. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|