| auszookers.com https://auszookers.com/forum/ |
|
| ball joints... https://auszookers.com/forum/viewtopic.php?f=5&t=11003 |
Page 1 of 1 |
| Author: | 31zook [ Fri Apr 09, 2010 11:10 pm ] |
| Post subject: | ball joints... |
So in the sierra steering department, there is a ball joint that sits at the end of the rod that goes to the steering box to the lower link. Mine is flogged out and giving my death wobbles, but no shop has a replacement. Im thinking i will need to buy another new one or do they press out? I got another one off a mate for now but still wondering... cheers 
|
|
| Author: | royce [ Fri Apr 09, 2010 11:15 pm ] |
| Post subject: | Re: ball joints... |
once apon a time there was a thread about these, and they do make new ones |
|
| Author: | Brett [ Fri Apr 09, 2010 11:25 pm ] |
| Post subject: | Re: ball joints... |
they press out but i just use two hammers if your never going to use it again |
|
| Author: | v.w.dave [ Sat Apr 10, 2010 12:48 am ] |
| Post subject: | Re: ball joints... |
They press out but can bend the arm/bar around it. I would use a little heat if you can. |
|
| Author: | 31zook [ Sat Apr 10, 2010 1:42 am ] |
| Post subject: | Re: ball joints... |
cheers guy's i thought they pressed out but i wasn't sure or wanted to just stick a piece of cast under a press and eat it. 
|
|
| Author: | Built4thrashing [ Sat Apr 10, 2010 12:11 pm ] |
| Post subject: | Re: ball joints... |
Just buy all new arms. complete setup was only $250 from suziworld here in vic. Wasn't aware you could replace just the balljoints. none of the parts places i spoke to knew it was able to be done. B4T |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|