| auszookers.com https://auszookers.com/forum/ |
|
| rings gone. 1.3 any help in a recon? https://auszookers.com/forum/viewtopic.php?f=5&t=11236 |
Page 1 of 1 |
| Author: | manup [ Sun Apr 18, 2010 9:39 pm ] |
| Post subject: | rings gone. 1.3 any help in a recon? |
hi, my rings are gone in my lil 91 sierra 1.3. Been lookin at doin a conversion but a bit picey. Now wondering if any1 has rebuilt the 1.3? If so what it cost and where? Wollongong /sydney area Thanx |
|
| Author: | eldo [ Sun Apr 18, 2010 9:49 pm ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
just get a good 2nd hand donk |
|
| Author: | eldo [ Sun Apr 18, 2010 9:49 pm ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
i think jimbo still has his stock engine |
|
| Author: | 89_tintop [ Sun Apr 18, 2010 10:23 pm ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
hey mate... i recently rebuilt mine set me back about 800 for rebuild gasket set rings big end bearings main bearings bore and deck the block reco the head timing belt rear main seal water pump oil and filter and some other stuff i probably forgot they are cheap and easy to rebuild. |
|
| Author: | Fmoss3 [ Mon Apr 19, 2010 1:24 am ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
hey mate mine only had 128k's on it before it shit a piston. ended up setting me back around 600 for new pistons, rings, mains, big ends, bearings, only thing i didn't change was the waterpump. Was working fine, DONT TOUCH IT 
Anyway, whole rebuild only took the full weekend although with the low k's i only had to re seat the valves and gave it a light hone. best of luck |
|
| Author: | Fmoss3 [ Mon Apr 19, 2010 1:26 am ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
if it sounds like too much work and effort, you can prob get a 2nd handy for half the price. swapping it over is a piece of piss but you just wanna make sure the engine your putting in is good enough. |
|
| Author: | manup [ Mon Apr 19, 2010 2:06 am ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
where do i look for a good second hand motor? |
|
| Author: | manup [ Mon Apr 19, 2010 2:07 am ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
in the nsw sydney, wollongong area? |
|
| Author: | eldo [ Mon Apr 19, 2010 2:25 am ] |
| Post subject: | Re: rings gone. 1.3 any help in a recon? |
try searching the for sale section on here or outers etc |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|