| auszookers.com https://auszookers.com/forum/ |
|
| NT to WT transfer case https://auszookers.com/forum/viewtopic.php?f=5&t=11947 |
Page 1 of 1 |
| Author: | thompson_2986 [ Mon May 17, 2010 11:02 pm ] |
| Post subject: | NT to WT transfer case |
Just wondering whats involved to change a NT transfer case to a WT. Cheers |
|
| Author: | Zook_Fan [ Mon May 17, 2010 11:04 pm ] |
| Post subject: | Re: NT to WT transfer case |
if you are putting a NT T-case into a WT you need to take the brake assembly off the back of it and wack a flange on. |
|
| Author: | Scrawny [ Mon May 17, 2010 11:18 pm ] |
| Post subject: | Re: NT to WT transfer case |
And change flanges on driveshafts to suit the bigger size |
|
| Author: | thompson_2986 [ Tue May 18, 2010 3:22 am ] |
| Post subject: | Re: NT to WT transfer case |
Where would i be looking to buy these flanges?? |
|
| Author: | ninjadaniel [ Tue May 18, 2010 4:05 am ] |
| Post subject: | Re: NT to WT transfer case |
i think they are called Yolks. |
|
| Author: | shep [ Tue May 18, 2010 5:22 am ] |
| Post subject: | Re: NT to WT transfer case |
if you have a wt that you want to put a nt transfer case in. you remove handbrake stuff and then swap all the flanges from the old box onto the new. assuming that it is a 1.3 sierra.  ya basically put ya new box next to ya
old box and swap the bits that are different 
|
|
| Author: | joeblow [ Tue May 18, 2010 5:33 am ] |
| Post subject: | Re: NT to WT transfer case |
|
|
| Author: | thompson_2986 [ Tue May 18, 2010 5:56 am ] |
| Post subject: | Re: NT to WT transfer case |
Thanks Shep JoeBlow I did use search to try and find my answer before I put up the question but the amount of extra stuff that I went through to try and find my answer didn't help. Maybe for common questions we should have a section like the tech articles. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|