auszookers.com
https://auszookers.com/forum/

85 sierra vacuum secondary
https://auszookers.com/forum/viewtopic.php?f=5&t=12228		 Page 1 of 1
Author:  Shansh [ Thu May 27, 2010 8:09 am ]
Post subject:  85 sierra vacuum secondary
where does the other end if that little black rubber pipe that goes onto the diaphragm go on the carby? i accidently pulled it right off when I was trying to check if the secondary is opening
Author:  Che [ Thu May 27, 2010 11:20 am ]
Post subject:  Re: 85 sierra vacuum secondary
Trying to check in the dark with my mobile... will confirm in the daylight.

Can't trace it comin out the motor side of the carb - but it's pretty much a bundle of lines in the general area.

Looking from over the driver's fender - seems to attach to something pretty much right behind the vacuum pot, about an inch or so further in on the carb. Could be completely wrong... like I said, i'll confirm in the daylight.

Here's an old pic I have to show the general direction it runs (maybe the same carb as an 85?):


Image
Author:  Shansh [ Thu May 27, 2010 9:10 pm ]
Post subject:  Re: 85 sierra vacuum secondary
che_guitarra wrote:
Trying to check in the dark with my mobile... will confirm in the daylight.

Can't trace it comin out the motor side of the carb - but it's pretty much a bundle of lines in the general area.

Looking from over the driver's fender - seems to attach to something pretty much right behind the vacuum pot, about an inch or so further in on the carb. Could be completely wrong... like I said, i'll confirm in the daylight.

Here's an old pic I have to show the general direction it runs (maybe the same carb as an 85?):


Image


thanks mate, i got it, the diaphragm is stuffed, the pipe goes to a little port just under the vacuum pot, its a real bitch to get to, appreciate the help though. 8)
Page 1 of 1 All times are UTC + 9:30 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/