| auszookers.com https://auszookers.com/forum/ |
|
| Fitting a winch to the GV 2002 SWB https://auszookers.com/forum/viewtopic.php?f=5&t=12279 |
Page 1 of 1 |
| Author: | lizzard [ Fri May 28, 2010 11:05 pm ] |
| Post subject: | Fitting a winch to the GV 2002 SWB |
Fitting a winch to the GV 2002 SWB Picked up a second hand alloy bullbar this week and have a little Aldi winch Now the problem starts where how do I fit it??? The bar dosnt have a cut out but the 4" grinder can fix that. Do I need to make a mount plate to fix to the chassis. |
|
| Author: | steak_knife [ Fri May 28, 2010 11:28 pm ] |
| Post subject: | Re: Fitting a winch to the GV 2002 SWB |
lizzard wrote: Fitting a winch to the GV 2002 SWB
Picked up a second hand alloy bullbar this week and have a little Aldi winch Now the problem starts where how do I fit it??? The bar dosnt have a cut out but the 4" grinder can fix that. Do I need to make a mount plate to fix to the chassis. Most defiantly, if you see ANY wire's that have a YELLOW sheath or plug, don't f*#k with then. Thay are your air bag sensor's & harness, if you damage or cut the harness you WILL need to replace the harness, big poo poo if you repair a SRS harness. |
|
| Page 1 of 1 | All times are UTC + 9:30 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|